Safety and Installation Guide: How to Place your Egg Chair

Egg chairs are a popular addition to Australian patios and gardens, offering a unique way to unwind. However, for a safe and optimal experience, certain technical requirements regarding placement, surface stability, and weight limits must be respected. This guide outlines the essential safety standards for freestanding hanging furniture.

1. Understanding Weight Capacities

Every egg chair is engineered with a specific maximum weight load. It is vital to consult the technical specifications on the product page before use. Exceeding these limits can cause premature wear on the tension spring and the structural integrity of the steel frame.

• Single Egg Chairs: Typically designed for a weight capacity between 110kg and 150kg.
• Double Egg Chairs: Usually rated for up to 200kg to 240kg.

Note: These limits include the weight of the cushions and any additional accessories placed in the chair.

2. Required Clearance and Swing Space

While egg chairs are designed for gentle swaying rather than high-velocity swinging, they still require adequate clearance from surrounding objects to prevent damage to the frame or your home.

• Rear Clearance: Allow at least 50cm between the back of the chair stand and any wall or railing.
• Lateral Space: Maintain a minimum of 1 metre of clear space on either side to allow for easy access and natural movement.
• Height: Ensure the chair is placed on a flat surface with no low-hanging overhead obstructions like gutters or light fixtures.

3. Surface Stability and Grounding

The longevity of the powder-coated stand and the safety of the user depend heavily on the ground surface. At Eglorys, we recommend placing your chair on a hard, level surface.

• Recommended: Concrete, pavers, or solid timber decking. These surfaces ensure the weight is distributed evenly across the circular or U-shaped base.
• Avoid: Soft mud, uneven sand, or thick bark. Unstable ground can cause the stand to tilt, putting uneven pressure on the connecting bolts.

4. Routine Hardware Inspection

Australian conditions can cause natural expansion and contraction of metal components. We recommend a quick safety check every three months:

• The Spring: Inspect the heavy-duty spring for any signs of over-stretching.
• Safety Pins & Bolts: Ensure all locking pins are fully inserted and bolts are tightened.
• Connection Points: Check the carabiner and the chain for any signs of friction wear.